3m interconnect solutions http://www.3m.com/interconnects/ 3m is a trademark of 3m company. for technical, sales or or dering information call 800-225-5373 ul file no.: e68080 3m ? metpak ? hshm press-fit power header 2 mm type d, 176 signal/4 po wer contacts, 8 rows, straight hshm series ts-2080-02 sheet 1 of 3 date modified: march 8, 2007 ? up to 5 gb/s data rates ? low crosstalk at high frequencies ? 50/100 (single-ended /differential) impedance ? modular/scalable format iec 61076-4-101 ? 101 mated lines per linear inch ? four integrated 8.25 a power contacts ? integrated guide pin ? end-to-end stackable with 8 row 3m? metpak? hm and hshm headers ? see regulatory info rmation appendix (ria ) for chemical compliance information physical insulation material: high temperature th ermoplastic (lcp) flammability: ul 94v-0 contact material: copper alloy plating: see ordering information performance mechanical normal force (nominal): 0.57 n [ 58 g ] signal, 0.74 n [ 75 g ] shield, 0.98 n [ 100 g ] power engagement force (nominal): 0.32 n [ 33 g ] signal, 0.22 n [ 22 g ] shield, 1.42 n [ 145 g ] power separation force (nominal): 0.20 n [ 20 g ] signal, 0.20 n [ 20 g ] shield, 0.89 n [ 91 g ] power wipe (nominal, shortest contact): 2.67 mm [ 0.105 in. ] signal, 1.57 mm [ 0.062 in. ] shield,1.93mm [ 0.076 in. ] power durability: 250 cycles with tr40b plating application: this module is suitable for stand-alone use. (refer to iec-61076-4-101.) electrical data rate: 5 gb/s characteristic impedance: 50 w single-ended, 100 w differential current rating (fully loaded): 1 a at 70 c signal, 8.25 a at 70 c power insulation resistance: 10 4 mw at 100 v dc withstanding voltage: 750 v rms environmental temperature rating: -55c to +125c metpak is a trademark of 3m company.
3m interconnect solutions http://www.3m.com/interconnects/ 3m is a trademark of 3m company. for technical, sales or ordering information call 800-225-5373 3m ? metpak ? hshm press-fit power header 2 mm type d, 176 signal/4 po wer contacts, 8 rows, straight hshm series ordering information hshm - h176dpwrx - 8cpx - xxxxx high speed option: 4 =coaxial, column differential and stripline (75w) applications 5 =row differential applications plating m [ ? ]: tg30 = 0.76 [ 30 ] min. au contact area 2.54 [ 100 ] min. snpb terminal area 1.27 [ 50 ] min. ni all over (ria e2 & c2 apply) tr40b = 0.127 [ 5 ] min. hard au contact area, lubricated 1.02 [ 40 ] min. pdni contact area 0.10 [ 4 ] min. pd strike contact area 2.54 [ 100 ] min. snpb terminal area 1.27 [ 50 ] min. ni all over (ria e2 & c2 apply) tail length: 1 =4.4 mm signal, 3.5 mm shield, 2.0 power 2 =2 mm signal, power and shield standard configuration dim a = 5.3 mm for rows a through h for non-standard configurations contact sales representative (rows i and z not loaded) ts-2080-02 sheet 2 of 3 denotes shield column (tail only) omitted for the row differential pair part row f row e row d row c row b row a ro w z pin positions shield positions 1 2 3 4 5 6 7 8 9 10 p3p4 15161718192021222324 1 2 3 4 5 6 7 8 9 10 11 p1 p2 15 16 17 18 19 20 21 22 23 24 25 row differential configuration shown with protective caps* * caps to be removed after press-fit installation process dim a = pin mating length dim b = tail length coaxial, column differential and stripline configuration shown with protective caps* hshm-hxxxxx-8xpx-xxxxx rev x xxyy hshm-hxxxxx-8xpx-xxxxx rev x xxyy 18.00 .709 2.00 .079 2.00 .079 2.00 .079 2.00 .079 48.00 1.890 row g row h row i 49.85 1.963 15.15 .596 4.50 .177 1.50 .059 24.00 .945 21.40 .843 16.72 .658 5.00 .197 interstitial ground contacts signal contacts 13.40 .528 4.50 .177 dim a dim b 0 0.0 0.00 mm 3 0.3 0.13 mm [inch] tolerance unless noted [ ] dimensions for reference only
3m interconnect solutions http://www.3m.com/interconnects/ 3m is a trademark of 3m company. for technical, sales or ordering information call 800-225-5373 3m ? metpak ? hshm press-fit power header 2 mm type d, 176 signal/4 po wer contacts, 8 rows, straight hshm series recommended pcb hole mounting pattern for power center and single ended applications recommended pcb hole mounting pattern for row differential applications plated thru holes lo 0.10 m ab 2.00 1.00 2.00 1.00 48.00 a b c d e a 1 2 3 4 5 6 7 8 9 10 11 15 16 17 18 19 20 21 22 23 24 25 a b c d e 1 2 3 4 5 6 7 8 9 10 11 15 16 17 18 19 20 21 22 23 24 25 f g h f g hz z i i 24.00 22.10 23.90 2.00 2x 1x o dim f lo 0.05 m ab plated thru holes 348x o dim e 16.50 b 6.50 13.50 1.50 1.50 8x dia. finished hole dia. ?d? cu. thickness snpb thickness drilled hole dia. e 0.457 - 0.559 [.0180 - .0220] 0.025 - 0.045 [.0010 - .0018] 0.008 -0.018 [.0003 - .0007] 0.584 - 0.625 [.0230 - .0246] f 0.690 - 0.790 [.0270 - .0310] 0.025 - 0.045 [.0010 - .0018] 0.008 -0.018 [.0003 - .0007] 0.810 - 0.860 [.0318 - .0339] hole plating table mm [in.] ts-2080-02 sheet 3 of 3
regulatory information appendix 3m electronic solutions division/interconnect europe appendix e1: european union rohs directive 2002/95/ec, restriction of the use of certain hazardous substances in electrical & electronic equipment, as amended by eu commission decision 2005/618/ec. this product is rohs compliant 2005/95/ec. rohs compliant 2005/95/ec means that the product or part (product) does not contain any of the substances in excess of the maximum concentration values in eu directive 2002/95/ec, as amended by commission decision 2005/618/ ec, unless the substance is in an application that is exempt under eu rohs. unless otherwise stated by 3m in writing, this information represents 3ms best knowledge and belief based upon information provided by third party suppliers to 3m. in the event any product is proven not to conform with 3ms regulatory information appendix, then 3ms entire liability and buyers exclusive remedy will be in accordance with the warranty stated below. appendix e2: european union rohs directive 2002/95/ec, restriction of the use of certain hazardous substances in electrical & electronic equipment, as amended by eu commission decision 2005/618/ec this product contains lead in the compliant pin area in excess of the maximum concentration value allowed but is compliant by exemption under eu commission decision 2005/747/ec. rohs compliant 2005/95/ec means that the product or part (product) does not contain any of the substances in excess of the maximum concentration values in eu directive 2002/95/ec, as amended by commission decision 2005/618/ ec, unless the substance is in an application that is exempt under eu rohs. unless otherwise stated by 3m in writing, this information represents 3ms best knowledge and belief based upon information provided by third party suppliers to 3m. in the event any product is proven not to conform with 3ms regulatory information appendix, then 3ms entire liability and buyers exclusive remedy will be in accordance with the warranty stated below. appendix e3: european union rohs directive 2002/95/ec, restriction of the use of certain hazardous substances in electrical & electronic equipment as amended by commission decision 2005/618/ec. this product contains lead in the solder tail area in excess of the maximum concentration value allowed. unless otherwise stated by 3m in writing, this information represents 3ms best knowledge and belief based upon information provided by third party suppliers to 3m. in the event any product is proven not to conform with 3ms regulatory information appendix, then 3ms entire liability and buyers exclusive remedy will be in accordance with the warranty stated below. appendix e4: european union rohs directive 2002/95/ec, restriction of the use of certain hazardous substances in electrical & electronic equipment, as amended by eu commission decision 2005/618/ec. this product contains decabde in the insulating material in excess of the maximum concentration value allowed but is compliant by exemption under eu commission decision 2005/17/ec. rohs compliant 2005/95/ec means that the product or part (product) does not contain any of the substances in excess of the maximum concentration values in eu directive 2002/95/ec, as amended by commission decision 2005/618/ec, unless the substance is in an application that is exempt under eu rohs. unless otherwise stated by 3m in writing, this information represents 3ms best knowledge and belief based upon information provided by third party suppliers to 3m. in the event any product is proven not to conform with 3ms regulatory information appendix, then 3ms entire liability and buyers exclusive remedy will be in accordance with the warranty stated below. ria-2217-b
china appendix c1: china rohs electronic industry standard of the peoples republic of china, sj/t11363-2006, requirements for concentration limits for certain hazardous substances in electronic information products. this symbol, per marking for the control of pollution caused by electronic information products, sj/t11364-2006, means that the product or part does not contain any of the following substances in excess of the following maximum concentration values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. unless otherwise stated by 3m in writing, this information represents 3ms best knowledge and belief based upon information provided by third party suppliers to 3m. in the event any product is proven not to conform with 3ms regulatory information appendix, then 3ms entire liability and buyers exclusive remedy will be in accordance with the warranty stated below. appendix c2: china rohs 2 0 electronic industry standard of the peoples republic of china, sj/t11363-2006, requirements for concentration limits for certain hazardous substances in electronic information products. this symbol, per marking for the control of pollution caused by electronic information products, sj/t11364-2006, means that the product or part does contain a substance, as detailed in the chart below, in excess of the following maximum concentration values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. unless otherwise stated by 3m in writing, this information represents 3ms best knowledge and belief based upon information provided by third party suppliers to 3m. the numerical reference in the symbol above should not be construed as a representation regarding the products life or an extension of a product warranty. the product warranty is stated below. in the event any product is proven not to conform with 3ms regulatory information appendix, then 3ms entire liability and buyers exclusive remedy will be in accordance with the product warranty stated below. important notice all statements, technical information, and recommendations related to 3ms products are based on information believed to be reliable, but the accuracy or completeness is not guaranteed. before using this product, you must evaluate it and determine if it is suitable for your intended application. you assume all risks and liability associated with such use. any statements related to the product which are not contained in 3ms current publications, or any contrary statements contained on your purchase order shall have no force or effect unless expressly agreed upon, in writing, by an authorized officer of 3m. warranty; limited remedy; limited liability. this product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase. 3m makes no other warranties including, but not limited to, any implied warranty of merchantability or fitness for a particular purpose. if this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3ms option, to replace or repair the 3m product or refund the purchase price of the 3m product. except where prohibited by law, 3m will not be liable for any indirect, special, incidental or consequential loss or damage arising from this 3m product, regardless of the legal theory asserted. 3 electronic solutions division 6801 river place blvd. austin, tx 78726-9000 800/225-5373 www.3m.com/interconnects ria-2217-b ? 3m 2007 name and content of hazardous substances or elements
|
